Architectural window film for custom builders.

Yes. Blackridge Film specifies each pane based on its orientation, the room's use, and privacy requirements. Share the glazing schedule and the areas where heat, glare, or sightlines are a concern so those differences can be addressed in the film selection.

Start with the glazing schedule, glass manufacturer and model, existing coatings or films, window orientation, and any active warranty documents. Include the client's priorities for daylight, glare, appearance, and privacy. The installer should check the glass type and condition before recommending a film.

SHGC describes how much solar heat passes through the glazing. A lower value means less solar heat gain. Visible transmittance describes how much visible light passes through; a higher value means more daylight. Compare data using the same glass conditions so the figures are meaningful for the project.

Specified correctly, no. We sample-pane on site, hold the film against the glass in the actual light of the room, and choose the grade that matches the design intent. The films we install are engineered to read as glass, not as tint.

It can. Warranty terms and film compatibility depend on the window and film selected. If the windows are under an active manufacturer warranty, we confirm compatibility in writing with the manufacturer before any work starts. Keep that confirmation with the project documents.

Either. We prefer to come in after final clean for the 90-day glazing cure to start in a finished space. If your sequence calls for film during trim, we coordinate dust control and stage around the rest of the punch list.

Yes. Two million general liability, workers' comp on every crew member. Certificates issued to the GC, the architect, or the homeowner, named exactly the way your master spec calls for.

Yes. We keep the original spec on file. New work is matched to the original films so the home reads as one project, not a patchwork of changes over time.